2014-2019 Hiace · Service Manual ENGINE

Charging Failure

Circuit diagnosis · Vehicles built from Oct 2014

INSPECTION PROCEDURE


1. CHECK GENERATOR WITH CLUTCH PULLEY (ON-VEHICLE INSPECTION)
  1. Start the engine and visually check if the fan of the generator rotor assembly located inside the generator assembly is operating.

OK:
The fan of the generator rotor assembly is operating.



NG
REPLACE GENERATOR WITH CLUTCH PULLEY (Click here)
OK


2. CHECK GENERATOR WITH CLUTCH PULLEY (UNIT INSPECTION)
  1. Remove the generator assembly (Click here).

  1. Check the installation condition of the generator pulley cap.

    OK:
    The generator pulley cap is not loose or missing.

  1. Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).

    OK:
    No grease leaks (for wet pulley) or large build-up of particles (for dry pulley).

  1. Check the generator with clutch pulley for misalignment (interference with the generator assembly).

    OK:
    The generator with clutch pulley is correctly aligned (no interference with the generator assembly).

  1. A288972
    Turn the generator with clutch pulley clockwise and counterclockwise by hand and check for noise.

    OK:
    Noise does not occur when turned in both directions.

  1. Turn the generator with clutch pulley clockwise and counterclockwise by hand and visually check for runout.

    OK:
    The generator with clutch pulley does not have runout.

  1. A288971
    Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator with clutch pulley locks when turned clockwise and turns freely when turned counterclockwise.

OK:
The generator with clutch pulley locks when turned clockwise and turns freely when turned counterclockwise.



NG
REPLACE GENERATOR WITH CLUTCH PULLEY (Click here)
OK

REPAIR OR REPLACE GENERATOR ASSEMBLY (Click here)


← ON-VEHICLE INSPECTION (from Oct 2014)Noise Occurs from V-ribbed Belt or Generator Assembly (from Oct 2014) →