2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. INSTALL GENERATOR ASSEMBLY
  1. Install the generator assembly with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

  1. Connect the wire harness to terminal B with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Install the terminal cap.

  1. Connect the connector to the generator assembly.

  1. Attach the clamp and connect the wire harness.


2. INSTALL FAN AND GENERATOR V BELT
  1. Set the fan and generator V belt onto each part.

    HINT:
    When installing the fan and generator V belt, attach the fan and generator V belt to the No. 1 idler pulley sub-assembly last.

  1. While turning the V-ribbed belt tensioner assembly clockwise, remove the pin.

  1. Check that the fan and generator V belt fits properly in the ribbed grooves.

    NOTICE:
    Make sure that the fan and generator V belt is set properly on each pulley.


3. INSTALL INTERCOOLER AIR TUBE
  1. Install the intercooler air tube to the diesel throttle body assembly and tighten the hose clamp.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Connect the connector to the intake air temperature sensor.

  1. Install the air tube support bracket with the 3 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


4. INSTALL NO. 4 AIR HOSE
  1. Install the No. 4 air hose and tighten the 2 hose clamps.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Connect the oil return hose and slide the 2 clips to secure the hose.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← REASSEMBLY (from Jan 2017)PRECAUTION (from Oct 2014) →