B1615/14 Front Airbag Sensor LH Malfunction
Diagnostic trouble codes · Vehicles built Jan 2015 – Mar 2016
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
The front airbag sensor LH consists of a diagnostic circuit and frontal deceleration sensor, etc.If the center airbag sensor assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.
DTC B1615/14 is stored when a malfunction is detected in the front airbag sensor LH circuit.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1615/14 |
Either condition is met:
|
|
WIRING DIAGRAM




INSPECTION PROCEDURE
- NOTICE:
- When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Click here).
- After replacing the center airbag sensor assembly, refer to initialization (Click here).
- When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Click here).
| 1. CHECK FRONT AIRBAG SENSOR LH |
![]() ![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the front airbag sensor RH with LH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs (Click here).
Result Result
Proceed to
DTC B1615 is output
A
DTC B1610 is output
B
DTC B1610 and B1615 are not output
C
- HINT:
- Codes other than DTC B1610 and B1615 may be output at this time, but they are not related to this check.
Text in Illustration *1
Front Airbag Sensor RH
*2
Center Airbag Sensor Assembly
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Return the front airbag sensor LH and RH to their original positions and connect the connectors to them.
|
|
||||
|
|
||||
| C | ||
| ||

