Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM
Engine Switch Illumination Circuit
Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
The illuminated entry system controls engine switch illumination. WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Before replacing the certification ECU (smart key ECU assembly), refer to the smart entry and start system (for Entry Function) precaution (Click here ).
1. PERFORM ACTIVE TEST USING GTS (ENGINE SWITCH)
Using the GTS, perform the Active Test (Click here ).
Entry & Start
Tester Display
Test Part
Control Range
Diagnostic Note
Power/Engine SW Light
Engine switch illumination
ON/OFF
-
OK:
Engine switch illumination illuminates.
NG
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here )
2. INSPECT ENGINE SWITCH
Remove the engine switch (Click here ).
Inspect the engine switch (Click here ).
NG
OK
3. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - CERTIFICATION ECU [SMART KEY ECU])
Disconnect the I32 engine switch connector.
Disconnect the B75 certification ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
I32-9 (SWIL) - B75-19 (SWIL)
Always
Below 1 Ω
I32-6 (AGND) - B75-24 (AGND)
I32-9 (SWIL) - Body ground
Always
10 kΩ or higher
I32-6 (AGND) - Body ground
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)