2014-2019 Hiace · Service Manual BODY ELECTRICAL

Engine Switch Illumination Circuit

Circuit diagnosis · Vehicles built Jan 2015 – Mar 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

DESCRIPTION

The illuminated entry system controls engine switch illumination.

WIRING DIAGRAM

E290808E01

INSPECTION PROCEDURE

NOTICE:
Before replacing the certification ECU (smart key ECU assembly), refer to the smart entry and start system (for Entry Function) precaution (Click here).


1. PERFORM ACTIVE TEST USING GTS (ENGINE SWITCH)
  1. Using the GTS, perform the Active Test (Click here).

    Entry & Start 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Power/Engine SW Light
    Engine switch illumination
    ON/OFF
    -

    OK:
    Engine switch illumination illuminates.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT ENGINE SWITCH
  1. Remove the engine switch (Click here).

  1. Inspect the engine switch (Click here).



NG
REPLACE ENGINE SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - CERTIFICATION ECU [SMART KEY ECU])
  1. Disconnect the I32 engine switch connector.

  1. Disconnect the B75 certification ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I32-9 (SWIL) - B75-19 (SWIL)
    Always
    Below 1 Ω
    I32-6 (AGND) - B75-24 (AGND)
    I32-9 (SWIL) - Body ground
    Always
    10 kΩ or higher
    I32-6 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


← Engine Switch Illumination Circuit (Oct 2014 – Dec 2014)Engine Switch Illumination Circuit (Apr 2016 – Dec 2016) →