2014-2019 Hiace · Service Manual SECURITIES

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.
  3. If the problem only occurs in certain locations or at certain times of day, check for wave interference.
  4. If the vehicle components are added, check for wave interference from the added components.

Immobiliser System (w/ Smart Entry and Start System) 
Symptom
Suspected Area
See page
Security indicator light does not blink
Proceed to "Security Indicator Light Does not Blink"
Click here
Engine cannot be started*1
ID code box (immobiliser code ECU)
-
ECM
-
ECD system
-
Power source mode cannot be changed*1
Engine switch
Click here
Certification ECU (smart key ECU assembly)
-
Steering lock lock/unlock not possible*2
Steering lock ECU (steering lock actuator assembly)
Click here
Immobiliser system does not operate properly
Proceed to "Immobiliser System does not Operate Properly"
Click here
  1. *1: Refer to Problem Symptoms Table for Smart Entry and Start System (for Start Function) (Click here).
  2. *2: Refer to Problem Symptoms Table for Steering Lock System (Click here).
← PROBLEM SYMPTOMS TABLE (Dec 2015 – Mar 2016)PROBLEM SYMPTOMS TABLE (Jan 2017 – Nov 2017) →