2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014

NOTICE:
  1. When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
  2. When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.


1. REMOVE TIMING BELT
(Click here)

2. REMOVE INJECTOR ASSEMBLY
  1. w/ DPF: (Click here)
  2. w/o DPF: (Click here)

3. REMOVE CAMSHAFT TIMING PULLEY

  1. A100848
    Remove the bolt and camshaft timing pulley while holding the camshaft with a wrench.

  1. A323634E01
    Using SST, remove the camshaft timing pulley and set key.
    SST
    09950-40011   (09951-04010, 09952-04010, 09953-05010, 09957-04010)
    09955-04150  

  1. A070551E02
    Rotate the crankshaft approximately 90° counterclockwise from TDC to lower the piston.


4. REMOVE NO. 2 TIMING BELT COVER

  1. A051300E01
    Remove the nut, 4 bolts and No. 2 timing belt cover.


5. REMOVE NO. 2 CAMSHAFT

  1. A100849E02
    Position the key groove of the camshaft upward by turning the camshaft with a wrench.

  1. A100850E01
    Uniformly loosen the 15 bearing cap bolts in several steps in the sequence shown in the illustration and remove the bolts.

  1. Remove the 5 bearing caps.

  1. A051302E01
    Remove the No. 2 camshaft.


6. REMOVE CAMSHAFT

  1. A051303E01
    Remove the camshaft.


7. REMOVE CAMSHAFT SETTING OIL SEAL

  1. A243032
    Remove the oil seal from the camshaft.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →