2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014

NOTICE:
  1. When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
  2. When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
  3. After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE EGR COOLER ASSEMBLY
(Click here)

3. REMOVE INJECTION PIPE SUB-ASSEMBLY

  1. A239564
    Disconnect the 4 injector connectors.

  1. Remove the 4 bolts and detach the 3 clamps.

  1. A151629
    Remove the 2 bolts and 2 No. 2 injection pipe clamps.

  1. A151628
    Using a 17 mm union nut wrench, loosen the union nuts and remove the 4 injection pipes.


4. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

  1. A177108E01
    Remove the bolt and No. 2 injection pipe clamp.

  1. Remove the bolt and detach the No. 1 injection pipe clamp.

    NOTICE:
    If a No. 1 injection pipe clamp is removed from the fuel inlet pipe, replace the No. 1 injection pipe clamp with a new one.

  1. A177109
    Using a 17 mm union nut wrench, loosen the union nuts and remove the fuel inlet pipe.


5. REMOVE COMMON RAIL ASSEMBLY
  1. Disconnect the pressure discharge valve connector and fuel pressure sensor connector.

  1. A177113
    Disconnect the fuel hose.

  1. A239565
    Remove the 2 bolts and common rail.

    NOTICE:
    Do not remove the pressure discharge valve or fuel pressure sensor.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →