2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE NO. 1 ENGINE UNDER COVER (for Cold Area Specification Vehicles)
  1. Remove the 4 bolts and No. 1 engine under cover.


2. REMOVE NO. 2 ENGINE UNDER COVER (for Cold Area Specification Vehicles)
  1. Remove the 6 bolts and No. 2 engine under cover.


3. REMOVE NO. 2 ENGINE SERVICE HOLE COVER (for Standard Body)
  1. Detach the clips and fold back the carpet.

  1. A151559
    Remove the 3 bolts and No. 2 engine service hole cover.


4. REMOVE DIESEL THROTTLE BODY ASSEMBLY
(Click here)

5. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

  1. C101768E02
    Remove the 2 bolts and transmission oil filler tube sub-assembly.

  1. Remove the O-ring from the oil filler tube sub-assembly.


6. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

  1. A172215
    Remove the bolt and engine oil level dipstick guide.

  1. Remove the O-ring from the engine oil level dipstick guide.


7. DISCONNECT NO. 1 GAS FILTER

  1. A172216
    Remove the bolt and disconnect the vacuum hose together with the No. 1 gas filter.


8. REMOVE INTAKE AIR TEMPERATURE SENSOR
  1. Disconnect the intake air temperature sensor connector.

  1. A257144E01
    Using a 22 mm ball joint lock nut wrench, remove the intake air temperature sensor.

  1. Remove the gasket from the intake air temperature sensor.


9. REMOVE VACUUM SWITCHING VALVE ASSEMBLY

  1. A242359
    Disconnect the connector from the electric EGR control valve.

  1. Detach the clamp and wire harness.

  1. A172220
    Disconnect the connector and vacuum hose from the vacuum switching valve.

  1. Remove the bolt and vacuum switching valve.


10. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR

  1. A242358
    Disconnect the vacuum hose.

  1. Remove the 2 bolts and manifold absolute pressure sensor.


11. REMOVE MANIFOLD STAY

  1. A172222
    Remove the 2 bolts and manifold stay.


12. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY
  1. Remove the 2 bolts and disconnect the No. 2 EGR pipe from the No. 2 EGR valve and gasket.

  1. Remove the bolt and 2 nuts, disconnect the electric EGR control valve together with the intake air connector from the intake manifold and remove the gasket.

  1. Remove the electric EGR control valve and gasket from the intake air connector.

  1. A172223
    Disconnect the connector from the vacuum regulating valve.

  1. Disconnect the 2 vacuum hoses from the vacuum regulating valve.

  1. Remove the 2 bolts and vacuum regulating valve.


13. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY

  1. A172224
    Remove the 2 nuts, No. 2 EGR pipe and gasket.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →