2014-2019 Hiace · Service Manual BODY

Vehicle Speed Signal Circuit

Circuit diagnosis · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017

DESCRIPTION

The vehicle speed sensor outputs speed signals to the door control relay assembly. If the vehicle speed is approximately 3 km/h (1 mph) or more, the door control relay assembly will not operate the power slide door.

WIRING DIAGRAM

(Click here)

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DOOR CONTROL RELAY ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. for LH Side

    1. Disconnect the q4 door control relay assembly connector.

    2. Disconnect the H20 combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      q4-26 (SPD) - H20-6 (+S)
      Always
      Below 1 Ω
      q4-26 (SPD) or H20-6 (+S) - Body ground
      Always
      10 kΩ or higher

  1. for RH Side, w/ Power Slide Door

    1. Disconnect the I4 door control relay assembly connector.

    2. Disconnect the H20 combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      I4-26 (SPD) - H20-6 (+S)
      Always
      Below 1 Ω
      I4-26 (SPD) or H20-6 (+S) - Body ground
      Always
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK COMBINATION METER ASSEMBLY
  1. Check that the vehicle speed sensor outputs the vehicle speed signal to the combination meter assembly (Click here ).



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Speed Signal Circuit (Jan 2015 – Dec 2016)Slide Door Handle Switch LH Circuit (from Oct 2014) →