2014-2019 Hiace · Service Manual BODY

Slide Door Handle Switch LH Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

When the power slide door ECU LH receives a switch signal from the slide door lock remote control LH (position switch), the power slide door ECU LH restricts operation of the power slide door.

WIRING DIAGRAM

B163015E02

INSPECTION PROCEDURE


1. INSPECT SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH (HANDLE SWITCH)

  1. B263248E01
    Disconnect the p7 connector from the slide door lock remote control assembly LH (handle switch).

  1. Measure the resistance of the handle switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    p7-1 - p7-2
    Handle in initial position
    10 kΩ or higher
    p7-1 - p7-2
    Handle pulled
    Below 1 Ω



NG
REPLACE SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH
OK


2. INSPECT SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH (POSITION SWITCH)

  1. B163012E02
    Disconnect the p5 connector from the slide door lock remote control assembly LH (position switch in the actuator).

  1. Measure the resistance of the position switch.

    Standard resistance:
    Tester Connection
    Door Lock Condition
    Specified Condition
    p5-1 - p5-4
    Lock
    10 kΩ or higher
    p5-1 - p5-4
    Unlock
    Below 1 Ω



NG
REPLACE SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH
OK


3. CHECK HARNESS AND CONNECTOR (HANDLE SWITCH CIRCUIT)

  1. B263181E01
    Disconnect the q4 connector from the power slide door ECU LH.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    q4-8 (MPX1) - p7-1
    Always
    Below 1 Ω
    q4-13 (OSG) - p7-2
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (POSITION SWITCH CIRCUIT)

  1. B163013E02
    Disconnect the q4 connector from the power slide door ECU LH.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    q4-22 (DLSW) - p5-4
    Always
    Below 1 Ω
    q4-13 (OSG) - p5-1
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER SLIDE DOOR ECU LH


← Vehicle Speed Signal Circuit (from Jan 2017)Slide Door Handle Switch RH Circuit (from Oct 2014) →