2014-2019 Hiace · Service Manual BODY

Power Slide Door LH does not Operate When Using Inside / Outside Handle

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

The power slide door ECU LH controls the power slide door and activates the slide door motor. When the door handle is pulled, the power slide door automatically moves to the fully open position.

WIRING DIAGRAM

(Click here ).

INSPECTION PROCEDURE


1. INSPECT SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH

  1. B263248E01
    Disconnect the p7 connector from the slide door lock remote control assembly LH (handle switch).

  1. Measure the resistance of the handle switch.

    Standard resistance:
    Tester Connection
    Handle Condition
    Specified Condition
    p7-1 - p7-2
    Handle in initial position
    10 kΩ or higher
    p7-1 - p7-2
    Handle pulled
    Below 1 Ω



NG
REPLACE SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY LH
OK


2. CHECK HARNESS AND CONNECTOR (SLIDE DOOR LOCK REMOTE CONTROL LH - POWER SLIDE DOOR ECU LH)

  1. B263181E01
    Disconnect the q4 connector from the power slide door ECU LH.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    q4-8 (MPX1) - p7-1
    Always
    Below 1 Ω
    q4-13 (OSG) - p7-2
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER SLIDE DOOR ECU LH


← Power Slide Door RH does not Operate When Satellite Switch is Pressed (from Jan 2017)Power Slide Door RH does not Operate When Using Inside / Outside Handle (from Oct 2014) →