2014-2019 Hiace · Service Manual BODY

Power Slide Door RH does not Operate When Using Inside / Outside Handle

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

The door control relay assembly controls the power slide door and activates the slide door motor unit RH. When the door handle is pulled, the power slide door automatically moves to the fully open position.

WIRING DIAGRAM

(Click here)

INSPECTION PROCEDURE


1. INSPECT SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY RH

  1. B263248
    Remove the slide door lock remote control assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Handle Condition
    Specified Condition
    1 - 3
    Handle in initial position
    10 kΩ or higher
    2 - 3
    1 - 3
    Handle pulled
    Below 1 Ω
    2 - 3



NG
REPLACE SLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY RH (Click here)
OK


2. INSPECT REAR DOOR WIRE RH

  1. B365974E01
    Disconnect the ci1 and fc1 rear door wire RH connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A-8 - B-11
    Always
    Below 1 Ω
    A-12 - B-17
    Always
    Below 1 Ω
    A-10 - B-16
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Rear Door Wire RH
    (Door Control Relay Assembly Side)
    *b
    Rear Door Wire RH
    (Slide Door Lock Remote Control Assembly RH Side)



NG
REPLACE REAR DOOR WIRE RH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (SLIDE DOOR LOCK REMOTE CONTROL RH - DOOR CONTROL RELAY ASSEMBLY)
  1. Disconnect the f4 slide door lock remote control RH connector.

  1. Disconnect the I4 door control relay assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    f4-2 - I4-20 (MPX2)
    Always
    Below 1 Ω
    f4-1 - I4-8 (MPX1)
    Always
    Below 1 Ω
    f4-3 - I4-13 (OSG)
    Always
    Below 1 Ω
    f4-2 or I4-20 (MPX2) - Body ground
    Always
    10 kΩ or higher
    f4-1 or I4-8 (MPX1) - Body ground
    Always
    10 kΩ or higher
    f4-3 or I4-13 (OSG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DOOR CONTROL RELAY ASSEMBLY (Click here)


← Power Slide Door LH does not Operate When Using Inside / Outside Handle (from Oct 2014)Jam Protection Function Activates During Power Slide Door LH Operation (from Oct 2014) →