Starter Signal Circuit
Circuit diagnosis · Vehicles built from Jan 2015
DESCRIPTION
for A/T:While the engine is being cranked, current flows from terminal ST1 of the ignition switch to the park/neutral position switch and to terminal STA of the ECM (STA Signal).
for M/T:
While the engine is being cranked, current flows from terminal ST1 of the ignition switch directly to terminal STA of the ECM (STA signal).
WIRING DIAGRAM
Refer to DTC P0617 (Click here).INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- HINT:
- This inspection procedure is based on the premise that the engine can crank normally. If the engine cannot crank normally, proceed to the problem symptoms table (Click here).
| 1. READ VALUE USING GTS (STARTER SIGNAL) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
Read the value.
- OK:
Ignition Switch Position
Starter Signal
ON
OFF
START
ON
Result Result
Proceed to
OK
A
NG (for A/T)
B
NG (for M/T)
C
|
|
||||
|
|
||||
| A | ||
| ||
| 2. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Inspect the park/neutral position switch assembly (Click here).
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY - ECM, IGNITION SWITCH) |
Disconnect the ignition switch connector.
Disconnect the ECM connector.
Disconnect the park/neutral position switch connector.
Remove the starter (ST) relay from the instrument panel relay block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H25-1 (ST1) - D37-4
Always
Below 1 Ω
B94-29 (STA) - D37-5
Always
Below 1 Ω
H25-1 (ST1) or D37-4 - Body ground
Always
10 kΩ or higher
B94-29 (STA) or D37-5 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. INSPECT IGNITION SWITCH |
Inspect the ignition switch (Click here).
|
|
||||
| OK | ||
| ||
| 5. CHECK HARNESS AND CONNECTOR (IGNITION SWITCH - ECM) |
Disconnect the ignition switch connector.
Disconnect the ECM connector.
Remove the starter (ST) relay from the instrument panel relay block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H25-1 (ST1) - B94-29 (STA)
Always
Below 1 Ω
H25-1 (ST1) or B94-29 (STA) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 6. INSPECT IGNITION SWITCH |
Inspect the ignition switch (Click here).
|
|
||||
| OK | ||
| ||
