C1440 Unusual Bank Angle Detected
Diagnostic trouble codes · Vehicles built Apr 2016 – Dec 2016
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.This is not a malfunction if the system and sensor circuits are normal and normal VSC operation resumes.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1440 |
Driving at a steep bank angle |
Yaw rate and acceleration sensor (Airbag sensor assembly) |
INSPECTION PROCEDURE
| 1. CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is recorded (Click here).
- Result:
Result
Proceed to
DTC C1440 is output
A
DTC C1440 is not output
B
Yaw rate and acceleration sensor DTC is output
C
|
|
||||
|
|
||||
| A | |
| 2. CLEAR DTC |
Clear the DTCs (Click here).
- HINT:
- If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
- It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
- If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
| NEXT | ||
| ||
