2014-2019 Hiace · Service Manual BRAKE

C1442 Invalid Data Received from Deceleration Sensor

Diagnostic trouble codes · Vehicles built Jan 2015 – Mar 2016

Also covers:

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Dec 2017

DESCRIPTION

The airbag sensor assembly has a built-in yaw rate and acceleration sensor.
The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
DTC No.
DTC Detection Condition
Trouble Area
C1442
When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from acceleration sensor is ON continuously for 10 seconds or more.
Acceleration sensor (Airbag sensor assembly)
C1443
When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from yaw rate sensor is ON continuously for 10 seconds or more.
Yaw rate sensor (Airbag sensor assembly)

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform zero point calibration and store system information (Click here).


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine and idle it for 60 seconds, and then stop the engine.

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTCs C1442 and C1443 are not output
    A
    DTCs C1442 and/or C1443 are output
    B



B
REPLACE AIRBAG SENSOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1440 Unusual Bank Angle Detected (from Dec 2017)C1442 Invalid Data Received from Deceleration Sensor (+ C1443) (Apr 2016 – Dec 2016) →