2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2017


VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY

  1. A398370E01
    Check for deformation and cracks in the compressor impeller on the intake side.
    Text in Illustration 
    *a
    Compressor Impeller
    If the compressor impeller is cracked or deformed, replace the turbocharger sub-assembly.

  1. A398371E01
    Check for deformation and cracks in the turbine wheel on the exhaust side.
    Text in Illustration 
    *a
    Turbine Wheel
    If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.


INSPECT AXIAL PLAY OF TURBINE SHAFT
  1. Using a dial indicator, insert the needle of the dial indicator into the exhaust side of the turbine shaft.

    NOTICE:
    Turbocharger sub-assembly and dial indicators are surely fixed when performing measurement.

  1. A345089
    Move the turbine shaft in the axial direction and measure the axial play of the turbine shaft.

    Maximum axial play:
    0.11 mm (0.00433 in.)

    If the axial play is more than the maximum, replace the turbocharger sub-assembly.


CHECK TURBINE SHAFT ROTATION

  1. A345091
    Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly.

    HINT:
    Even if it takes a little effort to rotate the turbine wheel, this is not a problem.

    If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.


INSPECT TURBOCHARGER NOZZLE VANE CONTROL ACTUATOR
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    1 to 100 Ω

    HINT:
    The temperature indicated in "Condition" is the temperature of the turbocharger nozzle vane control actuator.
    If the result is not as specified, replace the turbocharger nozzle vane control actuator.

← DISASSEMBLY (from Jan 2017)REASSEMBLY (from Jan 2017) →