2014-2019 Hiace · Service Manual CRUISE CONTROL SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

HINT:
  1. Use the following procedures to troubleshoot the cruise control system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the GTS to check if the CAN communication system is functioning normally (Click here).

      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B


    B.
    A

    4.CHECK FOR DTC*
    1. Check for DTCs (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs (Click here).

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Road Test (Click here)

    2. Terminals of ECM (Click here)

    3. Data List / Active Test (Click here)

    NEXT

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Oct 2014)HOW TO PROCEED WITH TROUBLESHOOTING (Jan 2015 – Nov 2015) →