2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017


1. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts and disconnect the tailpipe assembly from the exhaust pipe support.

  1. Remove the gasket.


2. REMOVE EXHAUST PIPE DAMPER

  1. A398372
    Remove the 2 bolts and exhaust pipe damper from the tailpipe assembly.


3. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 nuts then disconnect the center exhaust pipe assembly from the 2 exhaust pipe supports.

  1. Remove the gasket.


4. REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR

  1. A398615
    Remove the 3 bolts and No. 1 front floor heat insulator.


5. REMOVE NITROGEN OXIDES SENSOR

CAUTION:
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

  1. A398616
    Remove the 2 nuts, detach the connector and clamp, and then disconnect the harness and controller portion.

  1. A398617E01
    Using SST, remove the nitrogen oxides sensor.
    SST
    09224-00012  


6. REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR

  1. A396474
    Disconnect the connector from the No. 4 exhaust gas temperature sensor.

  1. A396476
    Using a 14 mm union nut wrench, remove the No. 4 exhaust gas temperature sensor from the front exhaust pipe assembly.


7. REMOVE UREA INJECTOR SET
(Click here)

8. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts, 2 compression springs and disconnect the front exhaust pipe assembly from the 2 exhaust pipe supports .

  1. Remove the gasket.

← COMPONENTS (from Jan 2017)INSTALLATION (from Jan 2017) →