2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT OIL PRESSURE SWITCHING VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    13 to 17 Ω

    If the result is not as specified, replace the oil pressure switching valve assembly.

  1. A263970E01
    Connect the positive (+) lead of the battery to terminal 1 and the negative (-) lead to terminal 2 and check that the operating sound of the oil pressure switching valve can be heard.

    NOTICE:
    1. This test must be performed within 10 seconds to prevent the coil from burning out.
    2. Always turn the voltage on and off at the battery, not the oil pressure switching valve.

    If the result is not as specified, replace the oil pressure switching valve assembly.

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →