2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY

  1. A239526E02
    Apply a light coat of engine oil to the O-ring of the oil pressure switching valve.

  1. Install the oil pressure switching valve with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Make sure that the O-ring is not cracked or jammed when installing the oil pressure switching valve.

  1. Connect the oil pressure switching valve connector.


2. ADD ENGINE OIL
  1. Add new engine oil.

    Standard Oil Grade:
    Item
    Oil Grade
    Oil Viscosity (SAE)
    w/ DPF
    ACEA C2
    (Using engine oil other than ACEA C2 may damage catalytic converter)
    - 0W-30
    - 5W-30
    w/o DPF
    G-DLD1, API CF-4, CF or ACEA B1
    (You may also use API CE or CD)
    - 5W-30
    - 10W-30
    - 15W-40
    - 20W-50


    Standard Capacity (w/ DPF):
    Item
    Fill Amount
    Drain and refill without oil filter change
    6.6 liters (7.0 US qts, 5.8 Imp. qts)
    Drain and refill with oil filter change
    6.8 liters (7.2 US qts, 6.0 Imp. qts)
    Dry fill
    7.5 liters (7.9 US qts, 6.6 Imp. qts)


    Standard Capacity (w/o DPF):
    Item
    Fill Amount
    Drain and refill without oil filter change
    6.8 liters (7.2 US qts, 6.0 Imp. qts)
    Drain and refill with oil filter change
    7.0 liters (7.4 US qts, 6.2 Imp. qts)
    Dry fill
    7.7 liters (8.1 US qts, 6.8 Imp. qts)

  1. Install the oil filler cap.


3. INSPECT FOR OIL LEAK
  1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.


4. INSPECT ENGINE OIL LEVEL
  1. w/ DPF: (Click here)
  2. w/o DPF: (Click here)
← INSPECTION (from Oct 2014)ON-VEHICLE INSPECTION (from Oct 2014) →