2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT INTAKE MANIFOLD

A359725

NOTICE:
Do not adjust the adjusting screw or 2 actuator installation bolts.

  1. A359726
    Check the operation of the swirl control valve.

    1. Check that the valve is fully opened under normal conditions.

    2. Connect a vacuum pump to the control valve. Check that the valve is fully closed when a negative pressure of 66.7 kPa (500 mmHg, 19 in.Hg) is applied.

    3. Leave it for 1 minute and check that the vacuum pump needle does not move. If the result is not as specified, replace the intake manifold.


INSPECT VACUUM SWITCHING VALVE
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance: 
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    33 to 39 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    10 kΩ or higher
    If the result is not as specified, replace the intake manifold.

  1. Check the operation according to the value(s) in the table below.

    1. G037162E09
      Check that air flows from port E to the filter. If the result is not as specified, replace the intake manifold.
      Text in Illustration 
      *a
      Port E
      *b
      Filter
      V100135
      Airflow

    2. Apply battery voltage across the terminals.

    3. A110309E10
      Check that air flows from port E to port F. If the result is not as specified, replace the intake manifold.
      Text in Illustration 
      *a
      Port E
      *b
      Port F
      V100135
      Airflow

← REMOVAL (from Jan 2017)INSTALLATION (from Jan 2017) →