2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

  1. A346703E02
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    33 to 39 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    1 MΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 vacuum switching valve assembly)
    If the result is not as specified, replace the No. 1 vacuum switching valve assembly.

  1. Check operation of the No. 1 vacuum switching valve assembly.

    1. A398468E01
      When a vacuum of 60 kPa (450 mmHg, 18 in.Hg) is applied to port F, check that air flows from port E to the filter.
      Text in Illustration 
      *a
      Vacuum
      *b
      Air
      *c
      Port E
      *d
      Port F
      *e
      Filter

    2. A346705E01
      Apply battery voltage 12 V across terminals 1 and 2.
      Text in Illustration 
      *a
      Air
      *b
      Port F
      *c
      Port E

    3. Check that air flows from port E to port F. If the result is not as specified, replace the No. 1 vacuum switching valve assembly.

← REMOVAL (from Jan 2017)INSTALLATION (from Jan 2017) →