2014-2019 Hiace · Service Manual ENGINE

P2200 NOx Sensor Circuit Bank 1 Sensor 1

Diagnostic trouble codes · Vehicles built from Jan 2017

Also covers:

DESCRIPTION

An nitrogen oxides sensor is installed in front exhaust pipe assembly, in order to detects the concentration of NOx and O2 in the exhaust gas.
P2200 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch ON for 3 seconds or more
An open or short circuit occurs in the nitrogen oxides sensor circuit for 3 seconds or more.
Nitrogen oxides sensor
P220E 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch ON for 3 seconds or more
An open or short circuit occurs in the nitrogen oxides sensor circuit for 3 seconds or more.
Nitrogen oxides sensor
Related Data List 
DTC No.
Data List
P2200
P220E
NOx Density B1S1

WIRING DIAGRAM

Refer to DTC U029D (Click here).

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. CHECK FOR DTC
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and turn the GTS on.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Read the DTCs.

Result 
Result
Proceed to
DTC P2200, P220E is output
A
DTC P2200 or P220E and other DTCs are output*
B

HINT:
*: If any other DTCs are output, perform troubleshooting for those DTCs first.



B
GO TO DTC CHART (Click here)
A


2. REPLACE NITROGEN OXIDES SENSOR
  1. Replace the nitrogen oxides sensor (Click here).


NEXT


3. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and turn the GTS on.

  1. Clear the DTCs (Click here).

  1. Ignition switch ON for 3 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Confirm that the DTC is not output again.


NEXT

END


← P21C5 Reductant Level Sensor "A" Stuck (from Jan 2017)P2226 Barometric Pressure Circuit (+ P2228, P2229) (from Jan 2017) →