The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51406A
3.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)
52618
4.REMOVE LOWER FRONT BUMPER ABSORBER
51405A
5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
51407A
6.REMOVE NO. 3 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 3 Engine Under Cover Sub-assembly)
17150
7.REMOVE EXHAUST MANIFOLD ASSEMBLY LH
28192
8.REMOVE STARTER COVER
Remove the 3 bolts and starter cover.
28100
9.REMOVE STARTER ASSEMBLY
Remove the bolt and disconnect the ground wire.
Disconnect the starter assembly connector.
Open the terminal cap.
Remove the bolt and nut, and disconnect the engine wire.
Remove the 2 bolts and starter assembly.
11363A
10.REMOVE FLYWHEEL HOUSING SIDE COVER
Remove the flywheel housing side cover from the cylinder block sub-assembly.