Home › Engine / Hybrid System › 7GR-FKS (STARTING) › STARTER
RM35X0E _51 Engine / Hybrid System _078665 7GR-FKS STARTING _0382031 STARTER A

7GR-FKS STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 11363A 1.INSTALL FLYWHEEL HOUSING SIDE COVER

a.

Install the flywheel housing side cover to the cylinder block sub-assembly.


Hide 28100 2.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the engine wire with the bolt and nut.

Torque:
Bolt : 13 N*m (133 kgf*cm, 10 ft.*lbf)
Nut : 9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter assembly connector.


e.

Connect the ground wire with the bolt.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 28192 3.INSTALL STARTER COVER

a.

Install the starter cover with the 3 bolts.

Torque:
11.5 N*m (117 kgf*cm, 8 ft.*lbf)


Hide 17150 4.INSTALL EXHAUST MANIFOLD ASSEMBLY LH

Hide 51407A 5.INSTALL NO. 3 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 3 Engine Under Cover Sub-assembly)

Hide 51405A 6.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 7.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 8.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART