Home › Engine / Hybrid System › 1GD-FTV (STARTING) › GLOW PLUG CONTROLLER
RM35X0E _51 Engine / Hybrid System _078666 1GD-FTV STARTING _0382048 GLOW PLUG CONTROLLER A

1GD-FTV STARTING  GLOW PLUG CONTROLLER  INSTALLATION  


PROCEDURE

Hide 28559 1.INSTALL GLOW PLUG CONTROLLER BRACKET

a.

Install the 2 glow plug controller brackets to the glow plug controller with the 4 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 2.INSTALL WIRE HARNESS CLAMP BRACKET (for LHD)

a.

Install the wire harness clamp bracket to the glow plug controller bracket with the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 28551 3.INSTALL GLOW PLUG CONTROLLER

a.

for LHD:

i.

Install the glow plug controller with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


ii.

Connect the 4 connectors and attach the 2 clamps.



b.

for RHD:

i.

Install the glow plug controller with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


ii.

Connect the 4 connectors and attach the clamp.



Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART