Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (for 2.0 kW Type)
RM35X0E _51 Engine / Hybrid System _078666 1GD-FTV STARTING _0382050 STARTER(for 2.0 kW Type) A

1GD-FTV STARTING  STARTER(for 2.0 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

for Automatic Transmission:

i.
A437459N01
2.854,0.552 3.01,0.75 0.156,0.198 10 true A 2.542,1.906 2.698,2.104 0.156,0.198 10 true B

Temporarily install the starter assembly with the nut and 2 bolts.


ii.

Tighten bolt A and nut B.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)



b.

for Manual Transmission:

i.

Temporarily install the starter assembly and clutch flexible hose bracket with the 2 bolts.


ii.

Connect the clutch release cylinder assembly with the 2 bolts.

Torque:
11.7 N*m (119 kgf*cm, 9 ft.*lbf)


iii.

Connect the wire harness clamp bracket to the clutch release cylinder assembly with the 2 nuts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


iv.

Tighten the 2 bolts.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)



c.

Connect the starter assembly connector.


d.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


e.

Close the starter terminal cap.


Hide 51405A 2.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 3.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 4.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART