Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (for 3.0 kW Type)
RM35X0E _51 Engine / Hybrid System _078666 1GD-FTV STARTING _0382051 STARTER(for 3.0 kW Type) A

1GD-FTV STARTING  STARTER(for 3.0 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Temporarily install the starter assembly and clutch flexible hose bracket with the 2 bolts.


b.

Connect the clutch release cylinder assembly with the 2 bolts.

Torque:
11.7 N*m (119 kgf*cm, 9 ft.*lbf)


c.

Connect the wire harness clamp bracket to the clutch release cylinder assembly with the 2 nuts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


d.

Tighten the 2 bolts.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


e.

Connect the starter assembly connector.


f.

Connect the starter wire with the nut.

Torque:
21.1 N*m (215 kgf*cm, 16 ft.*lbf)


g.

Close the starter terminal cap.


Hide 51408B 2.INSTALL ENGINE UNDER COVER SUB-ASSEMBLY RH

Hide 51495 3.INSTALL TRANSMISSION UNDER COVER

Hide 51405A 4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 5.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 6.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 8. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART