Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (w/ Stop And Start System)
RM35X0E _51 Engine / Hybrid System _078666 1GD-FTV STARTING _0382052 STARTER(w/ Stop And Start System) A

1GD-FTV STARTING  STARTER(w/ Stop And Start System)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

When the starter assembly is replaced, "STARTER relay" and "STARTER NO. 2 relay" must be also replaced.


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

NOTICE:

When the starter assembly is replaced, "STARTER relay" and "STARTER NO. 2 relay" must be also replaced.


a.

for Automatic Transmission:

i.
A437471N01
2.844,0.698 3,0.896 0.156,0.198 10 true A 3.021,1.865 3.177,2.063 0.156,0.198 10 true B

Temporarily install the starter assembly with the nut and 2 bolts.


ii.

Tighten bolt A and nut B.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)



b.

for Manual Transmission:

i.

Temporarily install the starter assembly and clutch flexible hose bracket with the 2 bolts.


ii.

Connect the clutch release cylinder assembly with the 2 bolts.

Torque:
11.7 N*m (119 kgf*cm, 9 ft.*lbf)


iii.

Connect the wire harness clamp bracket to the clutch release cylinder assembly with the 2 nuts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


iv.

Tighten the 2 bolts.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)



c.

Attach the clamp and connect the 2 starter assembly connectors.


d.

Install the starter wire with the nut.

Torque:
21.1 N*m (215 kgf*cm, 16 ft.*lbf)


e.

Close the starter terminal cap.


Hide 51408B 2.INSTALL ENGINE UNDER COVER SUB-ASSEMBLY RH (w/ Engine Under Cover Sub-assembly RH)

Hide 51495 3.INSTALL TRANSMISSION UNDER COVER (w/ Transmission Under Cover)

Hide 51405A 4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 5.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 6.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 28300 7.REPLACE STARTER RELAY AND STARTER NO. 2 RELAY

NOTICE:

When the starter assembly is replaced, "STARTER relay" and "STARTER NO. 2 relay" must be also replaced.


Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 9. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART