Home › Drivetrain › RC60J (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSMISSION SYSTEM (for 7GR-FKS)
RM35X0E _52 Drivetrain _078740 RC60J MANUAL TRANSMISSION / TRANSAXLE _0383349 MANUAL TRANSMISSION SYSTEM(for 7GR-FKS) L

RC60J MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION SYSTEM(for 7GR-FKS)  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:
·

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting and reconnecting the battery.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART





PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


NOTICE:

Performing iMT Installation Information Reset will clear the stored status of the iMT installation information (iMT Type). Make sure to perform iMT Installation Information Reset and set the iMT installation information (iMT Type) when replacing any of the parts shown in the following table.

Click hereDrivetrain>RC60J (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSMISSION SYSTEM (for 7GR-FKS)>INITIALIZATION

Replaced Part
ECM


HINT:

Use this function to reset the iMT installation information when the sensor is wrongly assembled or the ECM is reused.



PRECAUTION


HINT:
·

The iMT system may not detect the gear change performed by the driver when a certain amount of time elapses between the clutch operation and shift operation or when the shift lever is operated while coasting with the shift lever in N.

·

After the iMT system adjusts the engine speed and a certain amount of time elapses, the operation completes. Even during this time, the iMT system operates again if it detects a clutch pedal reengagement and a gear change operation.

·

The iMT system may not operate if the clutch pedal is not completely released and fully depressed.

·

When the clutch is quickly engaged, the speed synchronization operation by the iMT system may not occur in time.

·

When there is a malfunction in the engine system or ABS system, the iMT system may stop operating.