Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › 2019.02–2019.06
RM35X0E _51 Engine / Hybrid System _079220 1GD-FTV EMISSION CONTROL _0384162 DIFFERENTIAL PRESSURE SENSOR G

1GD-FTV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A343692

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


PROCEDURE

Hide 89481B 1.INSPECT DIFFERENTIAL PRESSURE SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.

Connect the GTS to the DLC3.


b.

w/ Cover:

Remove the No. 1 engine cover sub-assembly.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>DIESEL THROTTLE BODY>REMOVAL


c.

Slide the clamp and disconnect the air hose from the differential pressure sensor.


d.
A440880N01
0.875,2.333 0.604,1.948 0.604,1.948 0.427,1.948 true 0.115,1.854 0.458,2.042 0.344,0.188 10 false SST

Install SST to the differential pressure sensor.

SST
09992-00242  


e.

Turn the ignition switch to ON.


f.

Turn the GTS on.


g.

Enter the following menus: Powertrain / Engine / Data List / Particulate Filter Differential Pressure Bank 1.

Powertrain > Engine > Data List
Tester Display
Particulate Filter Differential Pressure Bank 1
50003 372 1138

h.
A440881C01
0,0 0,0 false
*a Pressure


Apply pressure to the differential pressure sensor assembly.


i.

Check the pressure value of the differential pressure sensor.

Standard pressure:

Approximately the same pressure as the applied pressure is indicated on the GTS.


NOTICE:

Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).


If the result is not as specified, check the differential pressure sensor circuit.


j.

Remove SST from the differential pressure sensor.


k.

Connect the air hose to the differential pressure sensor, and slide the clamp to secure the hose.


l.

w/ Cover:

Install the No. 1 engine cover sub-assembly.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>DIESEL THROTTLE BODY>INSTALLATION