Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › DIESEL THROTTLE BODY › 2019.02–2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387389 DIESEL THROTTLE BODY A

1GD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the diesel throttle body assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Replacement of diesel throttle body assembly Perform initialization - w/ DPF:
(Click here)
w/ Urea SCR System:
(Click here)
w/ EGR Cooler:
(Click here)
w/o EGR Cooler:
(Click here)

PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

a.
A443253

Remove the 2 nuts from the No. 1 engine cover bracket and No. 2 engine cover bracket.


b.

Detach the 2 clips and No. 1 engine cover sub-assembly from the No. 2 water by-pass pipe.

NOTICE:

Make sure to lift the No. 1 engine cover sub-assembly upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



Hide 51406A 2.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 52618 3.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 25761B 5.DISCONNECT NO. 1 VACUUM TRANSMITTING HOSE

Hide 17303T 6.REMOVE AIR PIPE SUB-ASSEMBLY

Hide 26100G 7.REMOVE DIESEL THROTTLE BODY ASSEMBLY

a.
A443560

Disconnect the intake air temperature sensor connector.


b.
A443550

Remove the bolt and disconnect the fuel hose bracket from the diesel throttle body assembly.


c.
A443551

for Cold Area Specification Vehicles:

Slide the 2 clips and disconnect the No. 11 water by-pass hose and No. 14 water by-pass hose from the diesel throttle body assembly.


d.
A443552

Disconnect the connector and clamp.


e.

Remove the 4 bolts, intake air connector, diesel throttle body assembly and 2 gaskets.


f.
A443553

Disconnect the connector to remove the emission control valve wire from the diesel throttle body assembly.