Home › Vehicle Exterior › LIGHTING (EXT) › SWITCH HOUSING › 2019.02–2019.06
RM35X0E _59 Vehicle Exterior _079256 LIGHTING (EXT) _0384419 SWITCH HOUSING A

LIGHTING (EXT)  SWITCH HOUSING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84319 1.INSTALL STEERING WHEEL SWITCH HOUSING

a.
E413251

If reusing the steering wheel switch housing:

i.

Using pliers, support the band clamp while loosened and set the steering wheel switch housing.


ii.
E413254C01
0,0 0,0 false
V113147

Install in this Direction


Push the steering wheel switch housing forward to attach the claw to install it.


iii.
E413255

Tighten the band clamp.



b.

If installing a new steering wheel switch housing:

i.
E413256

Set the steering wheel switch in place.


ii.
E413257C01
0,0 0,0 false
V113147

Install in this Direction


Push the steering wheel switch housing forward to attach the claw to install it.


iii.
E413258C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the pin to tighten the band clamp.



Hide 84329 2.INSTALL TURN SIGNAL SWITCH

Hide 84650 3.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 9.PERFORM SYSTEM INITIALIZATION AND CALIBRATION