Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 1GD-FTV)
RM35X0E _58 Vehicle Interior _079316 HEATING / AIR CONDITIONING _0384887 COMPRESSOR(for 1GD-FTV) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1GD-FTV)  REMOVAL  


PROCEDURE

Hide 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 51406A 2.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 52618 3.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 88359 5.REMOVE VISCOUS HEATER V BELT (w/ Viscous Heater)

Hide 16361A 6.REMOVE FAN AND GENERATOR V BELT

Hide 51108C 7.REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY LH

Hide 88703 8.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

a.
E415235C01
0.01,0.052 0.292,0.271 0.281,0.219 12 true *A 0.031,2.573 0.313,2.792 0.281,0.219 12 true *B
*A for Others
*B for Middle East


Remove the bolt and disconnect the discharge hose sub-assembly from the compressor assembly with magnet clutch.


b.

Remove the O-ring from the discharge hose sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88704 9.DISCONNECT SUCTION HOSE SUB-ASSEMBLY

a.
E415236C01
0.083,1.115 0.406,1.344 0.323,0.229 12 true *A 0.063,2.677 0.385,2.906 0.323,0.229 12 true *B
*A w/ Viscous Heater
*B w/o Viscous Heater


Remove the 2 bolts and each suction hose bracket.


b.
E415237

Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with magnet clutch.


c.

Remove the O-ring from the suction hose sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88320 10.REMOVE COMPRESSOR ASSEMBLY WITH MAGNET CLUTCH

a.
E415238

Remove the bolt and wire harness bracket.


b.
E415239

Disconnect the connector.


c.

Detach the clamp.


d.
E415240C01
0,0 0,0 false
V100135

Bolt
V100136

Nut


Remove the 2 bolts, 2 nuts.


e.
E415241

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with magnet clutch.

HINT:

Remove the compressor assembly with magnet clutch from the vehicle with the stud bolt remaining in the compressor assembly with magnet clutch.