88625A
1.INSTALL NO. 2 COOLER THERMISTOR (REAR EVAPORATOR TEMPERATURE SENSOR)
Install the No. 2 cooler thermistor (rear evaporator temperature sensor) as shown in the illustration.
| Position | Measurement |
|---|---|
| A | 130.8 to 140.8 mm (5.15 to 5.54 in.) |
| B | 45 to 55 mm (1.77 to 2.17 in.) |
| C | 56.1 mm (2.21 in.) (9 Fins) |
| D | 69.5 mm (2.74 in.) (11 Fins) |
| E | 96.3 mm (3.79 in.) (15 Fins) |
Be sure to insert the No. 2 cooler thermistor (rear evaporator temperature sensor) only once because reinserting it into the same position will not allow it to be firmly secured.
When reusing the evaporator, insert the No. 2 cooler thermistor (rear evaporator temperature sensor) one row next to the one that has been used previously.
After inserting the thermistor, do not apply excessive force to the wire.
88501R
2.INSTALL REAR EVAPORATOR SUB-ASSEMBLY
87103D
3.INSTALL REAR BLOWER WITH FAN MOTOR SUB-ASSEMBLY
87030A
4.INSTALL REAR COOLING UNIT ASSEMBLY