The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front air conditioning amplifier removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
67912A
3.REMOVE FRONT DOOR OUTSIDE SCUFF PLATE LH (for LHD)
67914B
4.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)
62112
5.REMOVE COWL SIDE TRIM BOARD LH (for LHD)
55641
6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER (for LHD)
58533C
7.REMOVE CENTER FLOOR CARPET COVER RH (for LHD)
88650N
8.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY (for LHD)
Remove the screw.
| *A | for Automatic Air Conditioning System | *B | for Manual Air Conditioning System |
| *a | Clamp | - | - |
|
Screw |
|
Connector |
|
Remove in this Direction | - | - |
Detach the clamp.
Disconnect the connector.
Detach the guide and remove the air conditioning amplifier assembly as shown in the illustration.
Disconnect each connector and remove the air conditioning amplifier assembly.
| *A | for Automatic Air Conditioning System | *B | for Manual Air Conditioning System |
67911B
9.REMOVE FRONT DOOR OUTSIDE SCUFF PLATE RH (for RHD)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
67913B
10.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
62111C
11.REMOVE COWL SIDE TRIM BOARD RH (for RHD)
Use the same procedure described for the LHD.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55641
12.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER (for RHD)
58533C
13.REMOVE CENTER FLOOR CARPET COVER RH (for RHD)
88650N
14.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY (for RHD)
| *a | Clamp |
|
Remove in this Direction |
Remove the screw.
Detach the clamp.
Detach the guide to remove the air conditioning amplifier assembly as shown in the illustration.
Disconnect each connector and remove the air conditioning amplifier assembly.