Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GD-FTV(w/ Variable Flow Control Solenoid Valve)) › 2019.02–2019.06
RM35X0E _55 Steering _078944 POWER ASSIST SYSTEMS _0388797 VANE PUMP(for 1GD-FTV(w/ Variable Flow Control Solenoid Valve)) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GD-FTV(w/ Variable Flow Control Solenoid Valve))  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during vane pump assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative when not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system


-

Learning completes when vehicle is operated normally

Effect/Inoperative when not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, do not overtighten it.

·

When installing the parts indicated by arrows, coat them with power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1GD-FTV(w/ Variable Flow Control Solenoid Valve))>COMPONENTS).



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Cover)

Hide 16361A 4.REMOVE FAN AND GENERATOR V BELT

Hide 5.DRAIN POWER STEERING FLUID

Hide 44348D 6.DISCONNECT NO. 2 OIL RESERVOIR TO PUMP HOSE

a.
C412749

Slide the hose clamp and disconnect the No. 2 oil reservoir to pump hose.


b.

Drain the power steering fluid.


Hide 44410 7.DISCONNECT PRESSURE FEED TUBE ASSEMBLY

a.
C412750

Disconnect the power steering oil pressure switch connector from the power steering oil pressure switch.


b.
C412751

Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.


c.

Remove the gasket from the pressure feed tube assembly.


Hide 44310 8.REMOVE VANE PUMP ASSEMBLY

a.
C412752

Remove the 2 bolts and vane pump assembly.