The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the door control receiver removal/installation are shown below.
1.REMOVE REAR SEAT ASSEMBLY LH
for Folding Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Folding Type)>REMOVAL
for Commuter, 3-Passenger Seat with 2-Point Type Seat Belt:
for Commuter, 3-Passenger Seat with 3-Point Type Seat Belt:
for Commuter, 4-Passenger Seat:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Commuter, 4-Passenger Seat)>REMOVAL
for Commuter, Single-Passenger Seat with 2-Point Type Seat Belt:
for Commuter, Single-Passenger Seat with 3-Point Type Seat Belt:
for Commuter, 2-Passenger Seat with 3-Point Type Seat Belt:
for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt and Headrest:
for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt without Headrest:
67935
2.REMOVE BACK DOOR SCUFF PLATE (for Full-trim)
73370E
3.REMOVE REAR SEAT OUTER BELT ASSEMBLY LH (for Full-trim)
58777A
4.REMOVE TOOL BAG HOLDER (for Full-trim)
62640M
5.REMOVE REAR QUARTER TRIM BOARD ASSEMBLY LH (for Full-trim)
62632D
6.REMOVE REAR QUARTER TRIM BOARD LH (for Semi-trim)
89741
7.REMOVE DOOR CONTROL RECEIVER
|
Bolt |
|
Connector |
Disconnect the connector.
Detach the guide to remove the bolt and door control receiver.
Do not subject the door control receiver to strong impacts or force, and do not drop it.
Do not reuse the door control receiver that has been dropped.