Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GD-FTV(w/o Variable Flow Control Solenoid Valve)) › 2019.02–2021.07
RM35X0E _55 Steering _078944 POWER ASSIST SYSTEMS _0389112 VANE PUMP(for 1GD-FTV(w/o Variable Flow Control Solenoid Valve)) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GD-FTV(w/o Variable Flow Control Solenoid Valve))  INSTALLATION  


PROCEDURE

Hide 44310 1.INSTALL VANE PUMP ASSEMBLY

a.

Install the vane pump with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.

Install a new gasket to the pressure feed tube assembly.


b.
C412799C01
0.406,1.406 0.375,1.042 true 0.292,1.438 0.51,1.635 0.219,0.198 10 true *a
*a Stopper


Install the union bolt and connect the pressure feed tube assembly to the vane pump assembly.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure that the stopper of the pressure feed tube touches the front housing.



c.

Connect the connector.


Hide 44348D 3.CONNECT NO. 2 OIL RESERVOIR TO PUMP HOSE

a.

Connect the No. 2 oil reservoir to pump hose to the vane pump assembly and slide the hose clip.


b.

Connect the connector to the power steering oil pressure switch.


Hide 16361A 4.INSTALL FAN AND GENERATOR V BELT

Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Cover)

Hide 6.ADD POWER STEERING FLUID

Hide 8.CHECK FOR POWER STEERING FLUID LEAK