Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR) › 2019.06–2021.07
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0395991 ECD SYSTEM(w/ Exhaust Gas Temperature Sensor for EGR) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Exhaust Gas Temperature Sensor for EGR)  P202A19  Reductant Tank Heater Control Circuit Performance Circuit Current Above Threshold  P20B919  Reductant Heater "A" Control Circuit Performance Circuit Current Above Threshold  


DESCRIPTION

Refer to DTC P202A12.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>P202A12

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P202A19 Reductant Tank Heater Control Circuit Performance Circuit Current Above Threshold When the tank heater is operating (temperature sensor value is equal to or less than a fixed value), overcurrent is detected multiple times (1 trip detection logic). Urea pump Class A DTC stored SAE Code: P209F
P20B919 Reductant Heater "A" Control Circuit Performance Circuit Current Above Threshold When the urea tube with heater is operating (ambient temperature sensor value is equal to or less than a fixed value), overcurrent is detected multiple times (1 trip detection logic). Urea tube with heater assembly Class A DTC stored SAE Code: P20BA

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P202A19 Reductant Tank Heater (Active Test)
P20B919 Reductant Pipe Heater (Active Test)

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.

Powertrain > Engine and Transmission > Trouble Codes
50001 456

d.

Read the DTCs.

Result:
Result Proceed to
DTC P202A19 or P20B919 is output A
DTC P202A19 or P20B919 and other DTCs are output* B


HINT:

*: If any other DTCs (CAN communication malfunctions or open/short circuits) are output, perform troubleshooting for those DTCs first.




A

2.CHECK AROUND BOTTOM OF VEHICLE

B

2.CHECK AROUND BOTTOM OF VEHICLE
a.

Check around the bottom of the vehicle.

HINT:

If the urea solution dries on an object, deposition occurs and leaves behind a white powder.


Area to check:

·

Areas connecting the urea pump and urea injector set.

·

Perforations in the urea tank sub-assembly.

·

Connectors not connected properly.

·

Clogging of the cooling fins of the urea injector set.

HINT:

If the cooling fins are clogged with foreign matter, remove the foreign matter and clean the cooling fins.




b.

Repair any trouble areas.


Result:
Proceed to
NEXT



NEXT

3.PERFORM ACTIVE TEST USING GTS (REDUCTANT PURGE)
3.PERFORM ACTIVE TEST USING GTS (REDUCTANT PURGE)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine and Transmission > Clear DTCs
50002 456

d.

Turn the engine switch off and wait for at least 30 seconds.


e.

Turn the engine switch on (IG) and turn the GTS on.


f.

Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Pump Check (Backward).

Powertrain > Engine and Transmission > Active Test
Tester Display
Reductant Pump Check (Backward)
50004 456 16

g.

Perform the Active Test.


h.

Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Purge.

Powertrain > Engine and Transmission > Active Test
Tester Display
Reductant Purge
50004 456 17

i.

Perform the Active Test.

HINT:

Perform the Reductant Purge to draw the urea solution back into the urea tank sub-assembly from the urea injector set.



Result:
Proceed to
NEXT



NEXT

4.CHECK DTC OUTPUT (DTC P202A19)
4.CHECK DTC OUTPUT (DTC P202A19)
a.

Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Tank Heater.

Powertrain > Engine and Transmission > Active Test
Tester Display
Reductant Tank Heater
50004 456 38

b.

Perform the Active Test.


c.

Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.

Powertrain > Engine and Transmission > Trouble Codes
50001 456

d.

Read the DTCs.


Result:
Result Proceed to
DTC P202A19 is output A
No DTC is output B



A

5.REPLACE UREA PUMP

B

6.CHECK DTC OUTPUT (DTC P20B919)
5.REPLACE UREA PUMP

Result:
Proceed to
NEXT



NEXT

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
6.CHECK DTC OUTPUT (DTC P20B919)
a.

Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Pipe Heater.

Powertrain > Engine and Transmission > Active Test
Tester Display
Reductant Pipe Heater
50004 456 37

b.

Perform the Active Test.


c.

Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.

Powertrain > Engine and Transmission > Trouble Codes
50001 456

d.

Read the DTCs.


Result:
Result Proceed to
DTC P20B919 is output A
No DTC is output B



A

7.REPLACE UREA TUBE WITH HEATER ASSEMBLY

B

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
7.REPLACE UREA TUBE WITH HEATER ASSEMBLY
a.

Replace the urea tube with heater assembly.


Result:
Proceed to
NEXT



NEXT

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine and Transmission > Clear DTCs
50002 456

d.

Turn the engine switch off and wait for at least 30 seconds.


e.

Turn the engine switch on (IG) and turn the GTS on.


f.

Using the GTS, perform the following Active Tests.

·

To check DTC P202A19:

Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Tank Heater.


Powertrain > Engine and Transmission > Active Test
Tester Display
Reductant Tank Heater
50004 456 38
·

To check DTC P20B919:

Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Pipe Heater.


Powertrain > Engine and Transmission > Active Test
Tester Display
Reductant Pipe Heater
50004 456 37

g.

Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.

Powertrain > Engine and Transmission > Trouble Codes
50001 456

h.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END