An electric heater is provided inside the urea tank and urea pipe, as urea solution freezes at -11°C (12.2°F) or lower.
The heater thaws frozen urea solution and prevents further freezing, allowing the urea SCR system to be started even in cold environments.
The tank heater turns ON and OFF according to the value of the temperature sensor. The heater for the urea tube with heater assembly turns ON and OFF according to the value of the ambient temperature sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P202A12 | Reductant Tank Heater Control Circuit High Circuit Short to Battery | When the tank heater is operating, an open or short circuit occurs in the tank heater for 3 seconds or more (1 trip detection logic). | ·
Open or short in tank heater circuit ·
Tank heater (urea pump) ·
Urea pump control ECU |
Class A | DTC stored | SAE Code: P202C |
| P202A14 | Reductant Tank Heater Control Circuit Low Circuit Short to Ground or Open | When the tank heater is operating, an open or short circuit occurs in the tank heater for 3 seconds or more (1 trip detection logic). | ·
Open or short in tank heater circuit ·
Tank heater (urea pump) ·
Urea pump control ECU |
Class A | DTC stored | SAE Code: P202B |
| DTC No. | Data List |
|---|---|
| P202A12
P202A14 |
Reductant Tank Heater |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P202A12
P202A14 |
Reductant Tank Heater (Active Test) |
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Inspect the tank heater (urea pump).
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA PUMP>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the urea pump connector.
Disconnect the urea pump control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| x4-9 (TH+) - N37-21 (HTT) | Always | Below 1 Ω |
| x4-11 (TH-) - N37-31 (EHTT) | Always | Below 1 Ω |
| x4-9 (TH+) or N37-21 (HTT) - Body ground and other terminals | Always | 10 kΩ or higher |
| x4-11 (TH-) or N37-31 (EHTT) - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Clear the DTCs.
Turn the engine switch off for 30 seconds or more.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Tank Heater.
| Tester Display |
|---|
| Reductant Tank Heater |
Perform the Active Test.
Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P202A12 or P202A14 is output | A |
| No DTC is output | B |
A
B
Replace the urea pump control ECU.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA PUMP CONTROL ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Clear the DTCs.
Turn the engine switch off for 30 seconds or more.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Tank Heater.
| Tester Display |
|---|
| Reductant Tank Heater |
Perform the Active Test.
Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT
Repair or replace the harness or connector.
| Proceed to |
|---|
| NEXT |
NEXT
Replace the urea pump.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA PUMP>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT