To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used. Using the atmospheric pressure, the ECM corrects the injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P222611 | Barometric Pressure Sensor "A" Circuit Short to Ground | Atmospheric pressure sensor voltage is 1.46 V or less for 3.0 seconds (1 trip detection logic). | ECM | Class A | DTC stored | SAE Code: P2228 |
| P222615 | Barometric Pressure Sensor "A" Circuit Short to Battery or Open | Atmospheric pressure sensor voltage is 4.85 V or higher for 3.0 seconds (1 trip detection logic). | ECM | Class A | DTC stored | SAE Code: P2229 |
| DTC No. | Data List |
|---|---|
| P222611
P222615 |
·
Atmospheric Pressure ·
Intake Manifold Absolute Pressure |
When the engine switch is on (IG), the intake manifold pressure, "Intake Manifold Absolute Pressure", is approximately equal to atmospheric pressure.
Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in elevation, pressure drops by 1 kPa. This varies by weather (high atmospheric pressure, low atmospheric pressure).
If DTC P222611 and/or P222615 is stored, the following symptoms may appear:
Misfire
Combustion noise
Black smoke
White smoke
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P222611
P222615 |
Engine switch on (IG) for 3 second or more |
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>REGISTRATION) and initialization (Click here Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Replace the ECM.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the engine switch off and wait for 30 seconds.
Turn the engine switch on (IG) and wait for 3 second or more.
Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT