86300C
1.INSTALL NO. 2 AMPLIFIER ANTENNA ASSEMBLY
| *A | for Standard Roof |
| *B | for High Roof |
|
Install in this Direction |
Install a new No. 2 amplifier antenna assembly as shown in the illustration.
| *A | for Standard Roof |
| *B | for High Roof |
|
Bolt |
|
Nut |
Install a new bolt and nut in the order shown in the illustration.
| *A | for Standard Roof |
| *B | for High Roof |
Connect the connector.
2.INSTALL TIRE PRESSURE WARNING ECU WITH WINDSHIELD HEADER PANEL DAMPER SUB-ASSEMBLY RH (for Standard Roof)
| *a | Clamp |
| *b | Guide |
|
Bolt |
|
Connector |
Attach the guide and clip to temporarily install the tire pressure warning ECU with windshield header panel damper sub-assembly RH.
Install the 4 bolts.
Attach the wire harness clamp.
Connect the connector.
3.INSTALL ROOF HEADLINING ASSEMBLY
for Standard Roof:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Wagon)>INSTALLATION
for High Roof:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-trim)>INSTALLATION
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6. PERFORM DIAGNOSTIC SYSTEM CHECK
7.CHECK SRS WARNING LIGHT
8.INSPECT SEAT BELT WARNING SYSTEM