Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
86101J
1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Standard Roof)
for Standard:
| *a | Clamp |
| *b | Guide |
|
Bolt |
|
Connector |
Attach the clamp and guide to install the No. 2 antenna cord sub-assembly.
Install the bolt.
Connect the 2 connectors.
w/ Digital Audio Broadcasting Antenna:
| *a | Clamp |
| *b | Guide |
|
Bolt |
|
Connector |
Attach the clamp and guide to install the No. 2 antenna cord sub-assembly.
Install the 2 bolts.
Connect the 3 connectors.
for ERA-GLONASS:
| *a | Clamp |
| *b | Guide |
|
Bolt |
|
Connector |
Attach the clamp and guide to install the No. 2 antenna cord sub-assembly.
Install the bolt.
Connect the 4 connectors.
86101J
2.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for High Roof)
for Standard:
| *a | Clamp |
| *b | Guide |
|
Bolt |
|
Connector |
Attach the clamp and guide to install the No. 2 antenna cord sub-assembly.
Install the bolt.
Connect the 2 connectors.
w/ Digital Audio Broadcasting Antenna:
| *a | Clamp |
| *b | Guide |
|
Bolt |
|
Connector |
Attach the clamp and guide to install the No. 2 antenna cord sub-assembly.
Install the 2 bolts.
Connect the 3 connectors.
for ERA-GLONASS:
| *a | Clamp |
| *b | Guide |
|
Bolt |
|
Connector |
Attach the clamp and guide to install the No. 2 antenna cord sub-assembly.
Install the bolt.
Connect the 4 connectors.
3.INSTALL ROOF HEADLINING ASSEMBLY
for Semi-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-trim)>INSTALLATION
for Full-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>INSTALLATION
for Wagon:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Wagon)>INSTALLATION
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)
for 7GR-FKS:
for 1GD-FTV:
5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (w/ Airbag System)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Airbag System)
7.CHECK SRS WARNING LIGHT (w/ Airbag System)
8.INSPECT SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)