The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the smart door control receiver assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
Use the same procedure described for the RH side.
1. PRECAUTION (w/ Pretensioner and Force Limiter)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)
for 7GR-FKS:
for 1GD-FTV:
Click hereGeneral>MAINTENANCE>1GD-FTV BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
897B0A
3.REMOVE ELECTRICAL KEY AND TPMS RECEIVER ASSEMBLY (w/ Tire Pressure Warning System)
4.REMOVE REAR SEAT ASSEMBLY LH
for Folding Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Folding Type)>REMOVAL
for Manual Captain Seat:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Manual Captain Seat)>REMOVAL
for Power Captain Seat:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Power Captain Seat)>REMOVAL
for 60/40 Split Seat Type 40 Side:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for 60/40 Split Seat Type 40 Side)>REMOVAL
for 60/40 Split Seat Type 60 Side:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for 60/40 Split Seat Type 60 Side)>REMOVAL
67935
5.REMOVE BACK DOOR SCUFF PLATE
73178C
6.REMOVE SEAT BELT ANCHOR COVER CAP (w/ Seat Belt)
73370E
7.REMOVE REAR SEAT OUTER BELT ASSEMBLY LH (w/ Seat Belt)
67918D
8.REMOVE REAR DOOR SCUFF PLATE LH
67872A
9.REMOVE NO. 1 SLIDE DOOR WEATHERSTRIP LH
Use the same procedure described for the RH side.
Pull back the No. 1 slide door weatherstrip LH so that the rear quarter trim board assembly LH can be removed.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR OPENING TRIM WEATHERSTRIP (for Wagon)>REMOVAL
62640M
10.REMOVE REAR QUARTER TRIM BOARD ASSEMBLY LH
89740A
11.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY
|
Bolt |
|
Connector |
Disconnect the connector.
Detach the guide to remove the bolt and smart door control receiver assembly.
Do not subject the smart door control receiver assembly to strong impacts or force, and do not drop it.
Do not reuse the smart door control receiver assembly that has been dropped.