The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the slide door control junction male removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
Use the same procedure described for the RH side.
1. PRECAUTION (w/ Pretensioner and Force Limiter)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)
for 7GR-FKS:
for 1GD-FTV:
Click hereGeneral>MAINTENANCE>1GD-FTV BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
73210
3.REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH
Use the same procedure described for the LH side.
for Full-trim:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY (for Full-trim)>REMOVAL
for Semi-trim:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY (for Semi-trim)>REMOVAL
84261B
4.REMOVE SLIDE DOOR CONTROL JUNCTION MALE
|
Bolt |
|
Connector |
Disconnect the connector.
Remove the 2 bolts and slide door control junction male.
67667A
5.REMOVE SLIDE DOOR WINDOW GARNISH RH (for Full-trim, for Standard Roof)
67667A
6.REMOVE SLIDE DOOR WINDOW GARNISH RH (for Full-trim, for High Roof)
67603
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY RH (for Semi-trim, for Type A)
67603
8.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY RH (for Semi-trim, for Type B)
67680B
9.REMOVE SLIDE DOOR TRIM BOARD ASSEMBLY RH (for Full-trim, for Standard Roof)
67680B
10.REMOVE SLIDE DOOR TRIM BOARD ASSEMBLY RH (for Full-trim, for High roof)
67851E
11.REMOVE SLIDE DOOR SERVICE HOLE COVER RH
84262B
12.REMOVE SLIDE DOOR CONTROL JUNCTION FEMALE
Disconnect the connector and detach the clamp.
|
Remove in this Direction |
Remove the 2 bolts and slide door control junction female as shown in the illustration.