Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR SENSOR › from 2019.06
RM35X0E _58 Vehicle Interior _079316 HEATING / AIR CONDITIONING _0384894 SOLAR SENSOR A

HEATING / AIR CONDITIONING  SOLAR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the solar sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement part or procedure Necessary procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*: w/ Stop and start system

Stop and start system* Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B475753

Be sure to read Precaution thoroughly before servicing.



NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 3.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

Hide 55990C 4.REMOVE CENTER DEFROSTER NOZZLE ASSEMBLY

Hide 89120A 5.REMOVE AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)

a.
E413283

Disconnect the connector.


b.

Detach the claw to remove the automatic light control sensor.

E413284C01
0,0 0,0 false
V113147

Remove in this Direction - -



Hide 88625H 6.REMOVE COOLER THERMISTOR (SOLAR SENSOR) (w/o Automatic Light Control System)

a.
E413283

Disconnect the connector.


b.

Detach the claw to remove the cooler thermistor (solar sensor).

E413284C01
0,0 0,0 false
V113147

Remove in this Direction - -