Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
Use the same procedure described for the RH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
84262B
1.INSTALL SLIDE DOOR CONTROL JUNCTION FEMALE
|
Install in this Direction |
for LH Side:
Install the slide door control junction female with the 2 bolts as shown in the illustration.
|
Install in this Direction |
for RH Side:
Install the slide door control junction female with the 2 bolts as shown in the illustration.
Connect the connector and attach the clamp.
67851E
2.INSTALL SLIDE DOOR SERVICE HOLE COVER RH
67603
3.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY RH (for Semi-trim, for Type A)
67603
4.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY RH (for Semi-trim, for Type B)
67680B
5.INSTALL SLIDE DOOR TRIM BOARD ASSEMBLY RH (for Full-trim, for Standard Roof)
67680B
6.INSTALL SLIDE DOOR TRIM BOARD ASSEMBLY RH (for Full-trim, for High Roof)
67667A
7.INSTALL SLIDE DOOR WINDOW GARNISH RH (for Full-trim, for Standard Roof)
67667A
8.INSTALL SLIDE DOOR WINDOW GARNISH RH (for Full-trim, for High Roof)
84261B
9.INSTALL SLIDE DOOR CONTROL JUNCTION MALE
|
Bolt |
|
Connector |
for LH Side:
Install the slide door control junction male with the 2 bolts as shown in the illustration.
Connect the connector.
|
Bolt |
|
Connector |
for RH Side:
Install the slide door control junction male with the 2 bolts as shown in the illustration.
Connect the connector.
73210
10.INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH
Use the same procedure described for the LH side.
for Full-trim:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY (for Full-trim)>INSTALLATION
for Semi-trim:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY (for Semi-trim)>INSTALLATION
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)
for 7GR-FKS:
for 1GD-FTV:
12. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
13. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Pretensioner and Force Limiter)
14.CHECK SRS WARNING LIGHT (w/ Pretensioner and Force Limiter)
15.INSPECT SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)