Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seat inner belt assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
The procedure listed below is a representative example.
Use the same procedure for first row and second row, unless otherwise specified.
1. PRECAUTION (for First Row)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
If the pretensioner has been deployed, replace any damaged parts as necessary.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for First Row)
Operate the rear power seat switch and move the ottoman to the uppermost position and seatback to the frontmost position.
Disconnet the cable from the negative (-) battery terminal.
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
3.REMOVE REAR SEAT ASSEMBLY LH
78060C
4.REMOVE NO. 1 SEAT SIDE TABLE ASSEMBLY (for First Row, RH Side)
84923
5.REMOVE REAR POWER SEAT SWITCH
72840K
6.REMOVE REAR NO. 1 SEAT ARMREST ASSEMBLY LH
71848W
7.REMOVE LH SEAT NO. 1 SEAT ADJUSTER COVER CAP
71H74
8.REMOVE REAR SEAT LOWER CUSHION SHIELD LH (for Second Row)
71866D
9.REMOVE LH SEAT REAR NO. 1 SEAT COVER BEZEL
71826C
10.REMOVE REAR SEAT CUSHION MOULDING LH
66990E
11.REMOVE REAR NO. 1 SEAT CUP HOLDER ASSEMBLY LH
72803H
12.REMOVE LH SEAT REAR NO. 1 SEAT ARMREST FRAME SUB-ASSEMBLY RH
71H75R
13.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER RH
73380D
14.REMOVE REAR SEAT INNER BELT ASSEMBLY
Disconnect the connector and detach the clamp.
Remove the bolt and rear seat inner belt assembly.